USB 3.0 will immediately slide to the market. USB 3.0 is dijuluki SuperSpeed USB will replace the preceding, USB 2.0 (Hi-Speed USB) that has been aged eight years
When the USB 2.0 transfer rate of increase was initially to be 480 Mbps 12 Mbps, USB 3.0 akan menaikkannya ten-fold into 4.8 Gbps. In 2007, Intel has been demonstrating the SuperSpeed USB in the Intel Developer Forum
Specification version 1.0 of the USB 3.0 has finished on 17 November 2008. Bi; a USB Impelementers Forum (USB-IF) specifications take over the management and publishing technical documents that are required, products that use the USB 3.0 protocol, developed by the factory hardware.
Compatibility
As well as the upgrade from 1.1 to USB 2.0 connector and a USB 3.0 cable is still compatible with the hardware that is designed for the USB versions before. Of course, you can not maximize the bandwidth of the device and the port without using the SuperSpeed USB 3.0 cable, however, at least you can still install the cable in the USB 3.0 port to 2.0
Compatibility is located on the connector design of the new UBS. USB 2.0 cable consists of four channels. A pair of channels for data transfer in / out, a path to power, and a path for grounding. USB 3.0 adds five new routes. New-path path is parallel with the old path. This means you will be able to distinguish between 2.0 to 3.0 cable to see only the tip of the konektornya
Two new channels will be dedicated to data transmission, while the other pair to handle the reception of data. This not only increases the speed significantly, but also allows USB 3.0 to read and write data in the same time. USB 2.0 on the data path for sending and receiving of data is not separated.
And Power Transfer
As mentioned above, has a USB 3.0 data transfer speeds tenfold the maximum limit of 480 Mbps USB 2.0
With this new speed, transfer 27 GB HD-quality movies into the future of media player it only takes 70 seconds. While the USB 2.0 to transfer the same data is required within 15 minutes even more.
Speed of this transfer can only be felt when you use a portable storage medium that is capable of writing data quickly. Solid state device will be much to enjoy the increased speed of this transfer, while the magnetic disk akan terkendala the RPM and speed read / write them. New flash-based device also must be developed in order to take advantage of this increased speed.
USB-IF record growth in the portable device to a battery charging via USB (mobile phone, MP3 player, digital camera, etc) Therefore, not only USB 3.0 is designed for faster data transfer, but also bring a greater power, range from 100 miliamp USB 2.0 on a 900 miliamp
One note on this new specification is the use of a more power efficient. USB 3.0 equipped with interrupt-driven protocol, a new power that will make the device non-active or idle (not currently in-charge by the USB port) does not tersedot by the host controller. To start data transfer, the device will send a first activation signal.
Operating System Support
In the event SuperSpeed Developers Conference, November 2008, Microsoft announced that Windows 7 has to support USB 3.0 can not be directly released now, but the Service Pack or update next. Similarly, on Windows Vista, which most likely will support USB 3.0. Until now, support for Windows XP, SuperSpeed still not known.
With the community behind open source, Linux will soon adopt the USB 3.0 specification is open to the public. As usual, Apple remains tight-lipped on the isue support SuperSpeed on Mac OS X. However, a growing opinion that menyakini Apple will adopt USB 3.0 even though a threat to their native interface, Firewire
See the enthusiasm and the readiness of the operating system developers, Linux users may be the first people to enjoy the new features in the USB 3.0. As usual, in each new software release, support for USB 3.0 will take place gradually. Initial support for this specification may not fully utilize the features available in USB 3.0
When the USB 2.0 transfer rate of increase was initially to be 480 Mbps 12 Mbps, USB 3.0 akan menaikkannya ten-fold into 4.8 Gbps. In 2007, Intel has been demonstrating the SuperSpeed USB in the Intel Developer Forum
Specification version 1.0 of the USB 3.0 has finished on 17 November 2008. Bi; a USB Impelementers Forum (USB-IF) specifications take over the management and publishing technical documents that are required, products that use the USB 3.0 protocol, developed by the factory hardware.
Compatibility
As well as the upgrade from 1.1 to USB 2.0 connector and a USB 3.0 cable is still compatible with the hardware that is designed for the USB versions before. Of course, you can not maximize the bandwidth of the device and the port without using the SuperSpeed USB 3.0 cable, however, at least you can still install the cable in the USB 3.0 port to 2.0
Compatibility is located on the connector design of the new UBS. USB 2.0 cable consists of four channels. A pair of channels for data transfer in / out, a path to power, and a path for grounding. USB 3.0 adds five new routes. New-path path is parallel with the old path. This means you will be able to distinguish between 2.0 to 3.0 cable to see only the tip of the konektornya
Two new channels will be dedicated to data transmission, while the other pair to handle the reception of data. This not only increases the speed significantly, but also allows USB 3.0 to read and write data in the same time. USB 2.0 on the data path for sending and receiving of data is not separated.
And Power Transfer
As mentioned above, has a USB 3.0 data transfer speeds tenfold the maximum limit of 480 Mbps USB 2.0
With this new speed, transfer 27 GB HD-quality movies into the future of media player it only takes 70 seconds. While the USB 2.0 to transfer the same data is required within 15 minutes even more.
Speed of this transfer can only be felt when you use a portable storage medium that is capable of writing data quickly. Solid state device will be much to enjoy the increased speed of this transfer, while the magnetic disk akan terkendala the RPM and speed read / write them. New flash-based device also must be developed in order to take advantage of this increased speed.
USB-IF record growth in the portable device to a battery charging via USB (mobile phone, MP3 player, digital camera, etc) Therefore, not only USB 3.0 is designed for faster data transfer, but also bring a greater power, range from 100 miliamp USB 2.0 on a 900 miliamp
One note on this new specification is the use of a more power efficient. USB 3.0 equipped with interrupt-driven protocol, a new power that will make the device non-active or idle (not currently in-charge by the USB port) does not tersedot by the host controller. To start data transfer, the device will send a first activation signal.
Operating System Support
In the event SuperSpeed Developers Conference, November 2008, Microsoft announced that Windows 7 has to support USB 3.0 can not be directly released now, but the Service Pack or update next. Similarly, on Windows Vista, which most likely will support USB 3.0. Until now, support for Windows XP, SuperSpeed still not known.
With the community behind open source, Linux will soon adopt the USB 3.0 specification is open to the public. As usual, Apple remains tight-lipped on the isue support SuperSpeed on Mac OS X. However, a growing opinion that menyakini Apple will adopt USB 3.0 even though a threat to their native interface, Firewire
See the enthusiasm and the readiness of the operating system developers, Linux users may be the first people to enjoy the new features in the USB 3.0. As usual, in each new software release, support for USB 3.0 will take place gradually. Initial support for this specification may not fully utilize the features available in USB 3.0
Comments
Post a Comment